High quality metal bellow mechanical seal burgmann MFWT,
Bellow Mechanical Seal, Fluid Seal, Mechanical Shaft Seal, Metal Bellow Seal, Pump Seal,
Features
•For unstepped shafts
•Single Seal
•Balanced
•Independent of direction of rotation
•Metal bellows rotating
Advantages
•For extreme high temperature ranges
•No dynamically loaded O-Ring
•Self-cleaning effect
•Short installation length possible
•Pumping screw for highly viscous media available (dependent on direction of rotation).
Recommended applications
•Process industry
•Oil and gas industry
•Refining technology
•Petrochemical industry
•Chemical industry
•Pulp and paper industry
•Hot media
•Highly viscous media
•Pumps
•Special rotating equipment
Combination Materials
STATIONARY RING: CAR/ SIC/ TC
ROTARY RING: CAR/ SIC/ TC
SECONDARY SEAL: GRAQHITE
SPRING AND METAL PARTS: SS/ H-C
BELLOW: AM350
WMFWT data sheet of dimension (mm)
Advantages of metal bellow mechanical seals
Metal bellows seals have many advantages over common pusher seals. The obvious advantages include:
- No dynamic o-ring eliminating the possiblity of hang-ups or shaft wear.
- Hydraulically balanced metal bellows allow the seal to handle more pressure without heat build up.
- Self Cleaning. Centrifugal force throws solids away from the seal face – Trim design allow fit into tight seal boxes
- Even face loading
- No Springs to clog
Most often metal bellows seals are thought of as High Temperature seals. But metal bellows seals are often effective in a wide range of other seal applications. The most common of these is chemical, general water pump applications. For many years an inexpensive form of metal bellows seals have been used very successfully in the waste water / sewage industry and in the agricultural fields pumping irrigation water. These seals were generally made of a formed bellows rather than a welded bellows. Welded bellows seals are much stronger and have superior flex and recovery characteristics which are more ideal to holding seal faces together but cost more to manufacture. Welded metal bellows seals are less prone to metal fatigue .
Because metal bellows seals only require one o-ring, and because that o-ring can be made with PTFE, metal bellows seals are and excellent solution on chemical applications where Kalrez, Chemrez,Viton, FKM, Buna, Aflas or EPDM are not compatible. Unlike an ASP Type 9 seal the o-ring will not cause wear because it is not dynamic. Installation with a PTFE o-ring must be done with more attention paid to surface of the shaft condition, however PTFE encapsolated o-rings are also available in most sizes to aid in sealing irregular surfacing..
We Ningbo Victor seal produce both standard mechanical seal and OEM mechanical seals
