single spring mechanical seals John crane Type 1 replacement G60 G9, SIC, Carbon

Short Description:

With its proven track record of exceptional performance, the Type W1 elastomer bellows seal is widely recognized as the industry’s workhorse. Suitable for a wide range of service conditions ranging from water and steam to chemicals and corrosive materials, the Type W1 mechanical seal is ideal for use in pumps, mixers, blenders, agitators, air compressors, blowers, fans and other rotary shaft equipment.

It is frequently used by the pulp and paper, petrochemical, food processing, wastewater treatment, chemical processing and power generation industries.

Send email to us

Product Detail

Product Tags

single spring mechanical seals John crane Type 1 replacement G60 G9, SIC, Carbon,
centriful pump seal, John crane mechanical seals, Mech Seal, Mechanical Pump Seal, Pump Shaft Seal, Water Pump Seal,

Replacement of Below Mechanical Seals

Burgmann MG901, John crane Type 1, AES P05U, Flowserve 51, Vulcan A5

Technical Features

Unbalanced
Single Spring
Bi-directional
Elastomer Bellows
Set screw lock collars available

Designed Features

To absorb both breakout and running torque, the seal is designed with a drive band and drive notches that eliminate overstressing of bellows. Slippage is eliminated, protecting the shaft and sleeve from wear and scoring.
Automatic adjustment compensates for abnormal shaft-end play, run-out, primary ring wear and equipment tolerances. Uniform spring pressure compensates for axial and radial shaft movement.
Special balancing accommodates higher-pressure applications, greater operating speeds and lower wear.
Non-clogging, single-coil spring allows for greater dependability than multiple spring designs. Will not run foul due to fluid contact.
Low drive torque improves performance and reliability.

Operating Range

Temperature: -40°C to 205°C/-40°F to 400°F (depending on materials used)

Pressure: 1: up to 29 bar g/425 psig 1B: up to 82 bar g/1200 psig
Speed: 20 M/S 4000 FPM
Standard size:12-100mm or 0.5-4.0 inch

Notes: The range of preesure,temperature and sliding velocity is depend on seals combination materials

Combination Material

Rotary Face
Carbon graphite resin impregnated
Tungsten carbide
Silicon carbide (RBSIC)
Stationary Seat
Aluminium oxide(Ceramic)
Silicon carbide (RBSIC)
Tungsten carbide 1

Auxiliary Seal
Nitrile-Butadiene-Rubber (NBR)
Fluorocarbon-Rubber (Viton)
Ethylene-Propylene-Diene (EPDM)
Spring
Stainless Steel (SUS304, SUS316)
Metal Parts
Stainless Steel (SUS304, SUS316)